ACK-450 is designed to use only Duracell MN1300
After installation, a transmitter function test must be performed
Moderators: sky's the limit, sepia, Sulako, North Shore
ACK-450 is designed to use only Duracell MN1300
After installation, a transmitter function test must be performed
New battery installation and battery reinstallation:
12. Perform an ELT self-test as follows:
a) Set the ELT local control switch in the “ON” position. The LED will begin flashing every 3-4 seconds.
b) Return the switch to the “ARM” position after 1-2 seconds. If the ELT is working properly, the LED will stay on for approximately 1 second.
c) If a 7-flash error code is indicated, there is a problem with the battery or battery connection wiring. Refer to Table 6 on page 37.
7.6 Test in accordance with Section 3.1 and Section 5.2: Function testing.
I was wondering that too. Are they calling for a DeoxIT type contact protective compound on the battery terminals?torquey401 wrote:Not sure what "ELT battery lube" is.
1. When installing the bottom four batteries in the battery case always lubricate the outside of the batteries with a light coat of paste wax, mild soap solution or silicon vacuum grease. Also lubricate the “O” ring at this time.
Silicone-based lubricants are often used by consumers in applications where other common consumer lubricants, such as petroleum jelly, would damage certain products, such as latex rubber condoms and gaskets on dry-suits. It can be used to lubricate fountain pen filling mechanisms and threads.